|
1. | First apply the bottom layer using the large body graphic installation instructions. If applying the flag stripe this would be the white layer.
|
|
2. | Once the previous layer is completely dry and the application tape has been removed you are ready to apply the next layer. Apply soapy water over and around the previous layer.
|
|
3. | Peel the paper backing off the next layer and and spray some soapy water on the sticky side.
|
|
4. | Apply the decal to the surface, the soapy water solution will allow you to reposition/slide it in to place.
|
|
5. | Squeegee as much water out from under the layer you just applied.
|
|
6. | Wait for it to completely dry, then slowly peel up the application tape. Make sure the decal doesn't peel up with it. If it does, work backwards and try peeling the tape off at a sharper angle or use a hair dryer to speed up the drying process.
|
|
7. | If you have any more layers, repeat from step 2. Otherwise you are done!
|
|
|
